12
Never expose the filter cartridge to direct contact with water
or solvents.
Note
SERVO GLAS4OOO
Your Servore welding helmet is strong and durable. It is designed to work in
temperatures between -5C and +55C. Do not use your helmet in very hot conditions
where temperatures exceed +65C. Always store your helmet in a clean dry place out of
the direct sun and protect it from exposure to moisture or extreme heat (min/max storage
temperature is -20C ~ +70C).
Avoid unnecessary impact or compression of your helmet and never use a helmet that is
damaged. Your Servore welding helmet is a quality professional tool and careful storage
will extend the life of your investment.
7. Storage and Temperature Range
Check your helmet shell and filter on a regular basis when in normal use and after
extended periods of storage. Never use a cracked or damaged helmet as this may result
in personal injury and will void your warranty.
Please replace any worn or damaged parts as necessary.
Genuine Servo Glas replacement parts are available from your authorized Servo Glas
distributor.
8. Inspection
After removing the welding filter from the shell the shell can be cleaned using a mild
detergent and water solution. Sweat bands can be washed. A silicone based lubricant
may be used on moving parts if necessary but is not normally required. The filter may be
carefully wiped with a cloth dampened with household window cleaning solution. Please
be careful not to scratch or otherwise damage the filter cartridge with fragments of
welding spatter or other abrasive dirt. Refer to the relevant parts diagram for illustrations
regarding assembly and disassembly.
9. Cleaning
www.servore.com
11
Always use good quality batteries of the correct type and be careful to
ensure they are inserted in the correct manner paying careful attention
to battery polarity.
Note
The Servo Glas 4000 uses two batteries to provide backup power. Always replace
both batteries at the same time. Batteries should be replaced either: (a) Every three
years or when the low battery warning lamp turns on (please also remove batteries and
store them separately if the helmet is to be stored for a long time.) (b) When the speed at
which the filter darkens decreases or when the density of the darkness of the screen is
reduced or uneven.
To replace the batteries, remove the filter from the retaining guide frame as explained in
6-3. You will then be able to slide out the battery cases on either side of the cartridge
and replace the batteries as shown in diagrams below.
6-4. Replacement of Battery
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels